34mm SeamGrip™
SeamGrip™ fastener for fixing to thin steel
Estimated lead times
1 Day
Estimated lead times
1 Day
Product Code
SG-SS-8.0 x 34
Lead Time
1 Day
Your price
Per 100
Qty
£1.42
(ex.VAT)
(ex.VAT)
Create New Favourites List
Key Features
Specification
Performance
Installation
Downloads
Description
For fastening materials such as brackets and cladding rails to thin sheet material
Features
- Combines 300 series stainless steel, screw and aluminium slotted sleeve to provide high resistance to vibration loosening
- After tightening, clamping tines remain in place even if a screw is removed
- Greater joint integrity with clamping force
To install: insert into an 8mm hole then install with a power driver and a 16mm closed-end or 17mm open-ended spanner
Length
34 mm
Diameter
8 mm
Grip Range Min
1.6 mm
Grip Range Max
6.3 mm
Installation Drive
Fixfast GreenDrive (8mm hex integral socket with retaining clip)
Pre-Drill Diameter
8 mm
Fastener pull-out performance
| NR,II,K (Tensile - Pull-out) | 0.5mm Steel: 1.58 kN |
Installation and handling
| Installation tool | Variable speed electric screw gun |
| Installation drive | Fixfast GreenDrive (8mm hex integral socket with retaining clip) |
| Correct installation | Fasteners should be driven within three degrees of perpendicular to the surface of the fastened material. Use a depth-setting nosepiece to avoid over-driving, and do not over-tighten. Variants with bonded washers should not have the rubber compressed to less than two-thirds of its uncompressed height. Care should be taken when engaging and disengaging from the fastener head to avoid damage to the protective coating. |
| Handling | Fasteners may have sharp edges, and the use of power tools can be dangerous. Use personal protective equipment. Store fasteners in dry conditions. Inspect each fastener before use and do not use damaged fasteners. |
Key Features
Description
For fastening materials such as brackets and cladding rails to thin sheet material
Features
- Combines 300 series stainless steel, screw and aluminium slotted sleeve to provide high resistance to vibration loosening
- After tightening, clamping tines remain in place even if a screw is removed
- Greater joint integrity with clamping force
To install: insert into an 8mm hole then install with a power driver and a 16mm closed-end or 17mm open-ended spanner
Specification
Length
34 mm
Diameter
8 mm
Grip Range Min
1.6 mm
Grip Range Max
6.3 mm
Installation Drive
Fixfast GreenDrive (8mm hex integral socket with retaining clip)
Pre-Drill Diameter
8 mm
Performance
Fastener pull-out performance
| NR,II,K (Tensile - Pull-out) | 0.5mm Steel: 1.58 kN |
Installation
Installation and handling
| Installation tool | Variable speed electric screw gun |
| Installation drive | Fixfast GreenDrive (8mm hex integral socket with retaining clip) |
| Correct installation | Fasteners should be driven within three degrees of perpendicular to the surface of the fastened material. Use a depth-setting nosepiece to avoid over-driving, and do not over-tighten. Variants with bonded washers should not have the rubber compressed to less than two-thirds of its uncompressed height. Care should be taken when engaging and disengaging from the fastener head to avoid damage to the protective coating. |
| Handling | Fasteners may have sharp edges, and the use of power tools can be dangerous. Use personal protective equipment. Store fasteners in dry conditions. Inspect each fastener before use and do not use damaged fasteners. |
Downloads
Related Products
